Enter Points from Your Existing Curves

Hydrology Studio allows you to enter intensities directly from your existing IDF curves or from data extracted from NOAA Atlas 14. You can also enter or import intensities from  NOAA Atlas 14.

Technically, when using existing curves, Hydrology Studio manipulates your input data to generate coefficients B, D & E, for use in an Intensity vs. Tc power equation shown below.

Your best source for this data is from NOAA’s National Weather Service “Precipitation Frequency Data Server”. Click the [NOAA] button on the Ribbon Toolbar to open the web server.

Then select your state and follow the instructions. Set the Data type to “Precipitation Intensity, Partial Duration” when using it for IDF curve setup.

Create IDF Curves from Existing Data

Choose Enter Intensities From Existing IDF Curves from the following screen. Then Click [Next].

The following screen appears that allows you to input data from either your existing IDF curves or from NOAA Atlas 14. See Importing from NOAA on how to directly import this data.

Clear the table and enter your intensities directly into the table. (You must supply the 5, 15, 30 and 60 minute values for each return period you want to use.)

Then click [Apply].

Click [Next] if you want to edit Correction Factors. Otherwise, click [Finish].

You’ll be taken back to the initial IDF Wizard screen where you’ll see your new IDF curves.

 

Save your curves by clicking the [Save] button and specifying a name for your file. An IDF extension will be applied. This file will automatically open each time you launch Hydrology Studio. You can, of course, change this file any time afterwards.

Troubleshooting IDF Curves

There may be occasions when the resulting curves do not exactly match the inputted data. As described above, the software manipulates your input data to generate coefficients B, D & E, for use in an Intensity vs. Tc equation. In other words the data must plot straight on log/log scale. If it does not, the software will make adjustments to the data, typically the 5 or 15 minute values, so that the data fits the equation. 

These adjustments are always within the lower and upper bounds of the 90% confidence interval as shown on the NOAA data tables. Keep in mind that NOAA generates this data from interpolating data points on a GIS grid and this will produce some irregularity.

You can make adjustments yourself in order to sway the curve in one direction or the other. For example, if the fitted curve is higher than the original data, adjust the D coefficient upwards until you are satisfied with the results. Do this by following the procedures here.

The NOAA Atlas estimates differ from some of the other resources that I have. Which are more accurate? Which should I use?

NOAA’s precipitation frequency estimates have been endorsed by the Federal Advisory Committee on Water Information’s (ACWI) Subcommittee on Hydrology and are de-facto national standards.

 

Related Articles