You can enter Frequency Correction Factors, Cf, with your IDF Curves. The Cf factors can be edited on the Known Equation Coefficients screen or the Computed Coefficients screens.
Cf factors are applied to the Runoff Coefficients when computing peak flows for the Rational methods. The intensities shown on your reports will not reflect this factor. The computed flows will, however. The product of C x Cf cannot exceed 1.0.
Correction Factors can be edited while you are setting up your IDF curves. Rather than clicking [Finish] just after entering or importing data, continue to click [Next] until you arrive at the Equation Coefficients screen shown below. There you can enter Cf values. Remember to click the [Apply] button when finished.
Edit the Correction Factors, Cf, on this screen.
Editing Correction Factors
If you need to edit existing Cfs, click on the [New…] button.
Then Click [Next]. Then [Next] again to reach the above screen.